Classroom Based Course:
CommScope 'Certified Installers' must be knowledgeable of Industry Standards and CommScope Product offering. To maintain the designation 'Uniprise Certified Installer' they must successfully complete either this 1-day instructor led OR the online SPUCIR standards-based training course. This course covers current ANSI Standards 568, 569, 606 and 607, NFPA 70 (NEC-2005), and termination and testing of UTP, FTP, and Fiber. The UCI course requires re-certification every 3 years using UCIR or the online SPUCIR course. 

This course is designed to take a student currently qualified in the CommScope UCI or SPUCI course, and re-certify them in that qualification. The Uniprise Installer Training Program is designed to assure that the installer is qualified to properly install the Enterprise Network (both inside and outside plant) using products that comprise a Uniprise solution. The training course covers telecommunications Standards 568, 569, 606, 607 and 758 and NFPA 70 (NEC), C2-2002 - National Electrical Safety Code® (NESC®), OSHA Regulations (Standards-29 CFR) – 1910, (1910.268, Telecommunications and 1910.146, Permit Required Confined Spaces). Participants are instructed on proper methodologies required for planning, placing, terminating and testing copper (horizontal cabling) and fiber (building backbone and outside plant) media in the campus structured cabling system.

Module Description
Module 1 - Introduction and Program Overview contains an overview of the course, the requirements for course completion and primary objectives.
Module 2 - Uniprise Product and Warranty Update – Twisted Pair and Optical Fiber Solutions, Cable and components.
Module 3 - Codes and Standards covers the NFPA 70 (NEC) 2005 and current ANSI Telecommunications Standards 568, 569, 606 and 607 applicable to the installation of telecommunications cabling solutions.
Module 4 - Copper Testing covers testing and troubleshooting of UTP, ScTP/FTP, and coaxial cable.
Module 5 - UTP and FTP Terminations/Testing covers methods and procedures for the termination and testing of a permanent link between a patch panel and a work area outlet. Includes lab exercise.
Module 6 - Optical Fiber Testing covers testing and troubleshooting of optical fiber utilizing the visual fault locator (VFL), OLTS and OTDR.
Module 7 - Optical Fiber Terminations covers methods and procedures for the termination and testing of the LC anaerobic optical fiber connector. Includes lab exercise.
Module 8 - Fiber Splicing covers mechanical and fusion splicing of optical fiber cabling. Includes lab exercise.

BICSI CEC’s: RCDD 7, Inst2 7, TECH 7, OSP 7

BICSI CEC's: RCDD 7, OSP 7, Inst 7, Tech 7